Bent or Straight front housing.
04-04-2012, 07:41 PM
#1
Registered User
Thread Starter
Join Date: Jun 2009
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Bent or Straight front housing.
Hey is there any way to determine if a front housing is bent just by looking at it??? the bare housing, no knuckles, no 3rd....
If not, how would I go about confirming that it is straight??
Help !!
If not, how would I go about confirming that it is straight??
Help !!
Last edited by jaxsondog; 04-11-2012 at 08:19 AM. Reason: old
04-11-2012, 08:24 AM
#4
Registered User
Thread Starter
Join Date: Jun 2009
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
"Jig bar". I took the housing to a rear end shop, they inserted this bar through the housing that seated tight against the axle seal seats, took a few measurements. All is good.
Thread
Thread Starter
Forum
Replies
Last Post
jasonty
Pre 84 Trucks (Build-Up Section)
41
12-23-2018 01:00 PM
FS[PacNorWest]: 1987 Toyota 4Runner $1800 Whidbey Island, WA
coreyedwards7611
Vehicles - Trailers (Complete)
4
01-16-2016 06:38 PM
Littlerick
General Vehicle Related Topics (Non Year Related)
6
09-10-2015 08:57 PM
