Mak92-4RnR's 1992 4Runner Build-Up Thread
#43
Registered User
Thread Starter
lmao if he wants to help, he's more than welcome. It kinda sucks that I need to do front and rear axle work... :/ the whole front is being replaced... lol
#44
Registered User
iTrader: (1)
keep in mind that keith has a 3" BL... it gives him a tad more room... plus the fact that hes running a different motor and tranny... different routing for the lines and whatnot...
idk... maybe it was easy for him... maybe he was more mechanically inclined...
to me, rebuilding the rear third was fairly easy... the front was a BISH...
idk... maybe it was easy for him... maybe he was more mechanically inclined...
to me, rebuilding the rear third was fairly easy... the front was a BISH...
#45
Registered User
Thread Starter
Im going to be pulling my entire front axle apart though... remember im doing CV joints as well... im pretty sure it'll be easy. I also need to pull my passenger side rotor... it has a grind mark in it :/ lol
#49
Registered User
oyah its easy to do cv's, just make sure you have that big socket for the one that holds the hub on and you will be good
oyah mak im putting my truck up forsale on bc4x4 lol its time
oyah mak im putting my truck up forsale on bc4x4 lol its time
#51
Registered User
Tired of it, drives like crap, runs like crap, and its too small. Simple as that. I jave 4500 into 3500 truck and my buddies 2200 4runner drives nicer and has less problems lol im selling it hopfully for 4000 then buying mu buddies 4 runner for 2000 and doing a 3.4 or 350 swap and run 33" s then i will be happy haha
Sorry mak for the hijack i know u are going to kill me for it lol
Sorry mak for the hijack i know u are going to kill me for it lol
#53
Registered User
Yeah lol up here there worth more and 4k is what its worth but im asking more ofcoarse lol if i see for 4000 then i loose 3500 bucks but i cant stand this truck lol its needs to be gone
#55
Registered User
Thread Starter
Alrighty Troy, I'll keep that in mind
Also, Im thinking of picking up some 25mm SWAY-A-WAY Torsion bars. what should I expect from going from stock ( i think its 22.8mm? ) to 25mm? Im only considering it because i have a TJM bumper and it holds my hi lift jack and eventually a winch and off road lights.
Also, Im thinking of picking up some 25mm SWAY-A-WAY Torsion bars. what should I expect from going from stock ( i think its 22.8mm? ) to 25mm? Im only considering it because i have a TJM bumper and it holds my hi lift jack and eventually a winch and off road lights.
Last edited by MaK92-4RnR; 06-08-2010 at 08:31 AM.
#60
Registered User
Thread Starter
it lights up everything... you can see in the pictures it hits the entire wall, puts beams on the ground.. i didn't take pictures of the bumper but it lights up the the bars that go around my head light too.